0908
Normal Operation
This section of the manual instructs an owner on routine operating procedures and
assumes that the water heater has already been installed, tested, and approved for
operation. Initial start up requirements is detailed in the “Installation” section of this
manual.
Routine Start Up
Follow this procedure for a heater that has been out of service.
1. Ensure all drain plugs are installed in unit.
2. Ensure all hot water use points (faucets, etc) are closed.
3. Open the water inlet valve.
4. Open a hot water faucet to confirm water flow and then close the faucet.
5. Open the fuel gas valve.
6. Plug in the unit, The message “CL” will be displayed indicating “Cold” state.
7. Press the “ON/OFF” key to turn on the unit.
8. Set temperature (see “Temperature Control” section of this manual).
- A 120 V / 60 Hz power source should be used. Fire, electrical shock or damage to
the water heater may occur if an incorrect power supply is used.
- This appliance is equipped with a three-prong grounded plug for increased
protection against electrical shock. Ensure the plug is properly inserted into a clean,
dry outlet that complies with all electrical codes. Only insert and remove the plug
using the plug head and never use a wet hand to plug or unplug the power plug.
- Any alterations to the appliance will void the warranty.
- GAS16LPETL gas tankless water heaters provide an efficient reliable supply of hot
water.
- The temperature can be adjusted between 95ºF and 149ºF (35ºC - 65ºC).
- Only a small amount of water and a low water pressure (15psi) are required for the
unit. Unit requires 0.67 gpm (2.5 l/min) to enable the unit. Unit stays in operation until
the flow drops below 0.53 gpm (2 l/min).
- The burner ignition is electronic. The unit has no pilot light and consumes no gas
when the heater is not being used.
- Air is brought into the unit from outside, efficiently burned with the appropriate
source of fuel and then exhausted externally.
- The unit's integrated control system constantly monitors the temperature of the
water being produced and adjusts the burner accordingly to deliver a stable supply
of hot water.
- The unit is highly flexible and provides hot water over a wide range of flow rates and
incoming water temperatures across the capacity range of the unit.
- GA16ETL heaters include a digital functionality that allows owners to control hot
water consumption and conserve water.
- Multiple protective functions are included such as no-load heating prevention,
automatic shutdown in case of accidental flame out, automatic pressure relief, etc.
to make the appliance both safe and reliable
- In the event of a disruption in operation, a failure code is displayed and an alarm
sounds an alert.
To Next Page
Loading...
Need help?
General
