1-7
MF 5650 ADVANCED
1. Safety Guidelines
1
6.3 - For transportation in a trailer-truck
• Always observe the maximum height and width
allowed for the cargo. • Disengage the
platform and fix it on the truck trailer. Also
remove the cover and the pre filter;
• Due to the machine’s width, it is necessary to
remove the wheels from the harvester, and
support it on the trailler through the axles.
NOTE:
Apart from the recommendations herein,
contact the Local Traffic Authority about
eventual aditional regulations, specific to
your area. The currently valid traffic
regulations must always be observed.
• The platform must be transported with another
truck, unless the trailling truck floor which is
carrying the machine has enough space to hold
both;
• Use only trucks with body size compatible with
the platform and position it correctly over the
truck’s floor and fix it firmly.
• Use wooden wedges under the axles and fix
them to the truck’s body.
• Disconnect the injection pump solenoid wire
and turn off the battery’s safety key in order to
prevent the engine to be accidentally started.
Fig. 4
6.4 - Maintenance safety
• Stop the engine before performing any service,
adjustment, repair, lubrication or removing a
clog, or when leaving the operator’s platform
for any reason.
• Make sure the safety device on the platform’s
hydraulic cylinder is locked, before performing
any service or checking beneath the platform.
• Make sure the cropping platform and the drum
are lowered, before disengaging any part from
the hydraulic system.
• Never remove radiator cap when engine is hot.
First, loose the cap to allow the steam to escape
and then remove the cap. This procedure will
prevent burns.
• Never disconnect any hydraulic line or perform
any repair if the line is pressurized. A spray of
pressurized oil can cause serious injuries in
your skin or cause infection in a existing injury
through the contact. I such cases, wash
immediatly the afected local with abundant
warm water and neutral soap. Then, call for
medical assistance.
• Take special care when you are close to belts,
chains, gears, pulleys or any other rotating part.
Loose clothing can get caught in rotating parts.
Adjustment in industrial parts in the moving
machine can only be performed in special
cases, as per mentioned in this Manual.
• Improvised equipment and tools can lead to
accidents. When adjusting or repairing the
harvester, use only the appropriate tools.
• After performing any service or maintenance
in the harvester, always check if all removed
parts and tools were collected.
• When lifting the equipment to remove the
wheels, support it on blocks or proper stands.
To Next Page
Loading...
Need help?
General
