1-12
MF 5650 ADVANCED
1. Safety Guidelines
1
Adjust the seat, put on the safety belt, apply the
parking brake and set all controls to neutral before
starting.
WARNING!
Start the engine with the starting key and
always sitting on the operator seat.
NEVER try to start the engine by a direct
start.
The machine will start engaged if the
safety switch circuit if turned. This may
cause severe injuries or death if there is
someone near the harvester.
9.4 - Follow the recommended starting
procedures
Follow the start procedures recommended in the
Maintenance Section in this Manual. Such
procedures include normal start, cold start and the
use of boost fluids.
9.5 - Test the controls
After starting the machine, check all meters and
lights again. Make sure everything is working
properly. If the harvester does not respond correctly
when every control is activated, DO NOT use the
machine until the problem is solved. Make sure
engine start solenoid cover is always in place.
9.6 - Start fluid
DO NOT use auxilliary start fluids in aerosol
packages in harvesters equipped with the reheating
system connected to the electrical system. Ether
combined with the preheating system may cause
explosions, damage the engine, provoke injury to
whoever is handling it or both.
Handle the start fluid correctly. The start fluid must
only be used when the ether start aid is used as
original default equipment or when installed as
accessory by the Dealer.
For harvesters equipped with glow plugs or
preheating system, these pieces of equipment must
be removed before installing an ether start device.
ATTENTION!
It is very important that you read and
follow all the instructions on the ether
can before installing the ether base cold
start aid in the harvester.
Fig. 11
To Next Page
Loading...
Need help?
General
