Underway
If the oil pressure gauge indicates low or
no oil pressure, immediately stop the boat
as outlined below and check the oil level. If
the temperature gauge indicates overheat-
ing, stop the boat when it is safe to do so as
outlined below and check the raw water sys-
tem for blockage. (See the Boat Operations
and Care and Maintenance sections of this
Owner’s Manual for directions on how to
properly check for the blockage.) DO NOT
operate the boat until the cause for the warn-
ing has been found and corrected.
Continued operation afer the warning light
has illuminated may cause severe engine
damage. This will void your warranty.
Stopping
Step 1: Slowly bring the control lever to
the neutral position. If the boat
has been driven for a long period
of time or at high speed, allow the
engine a two-to-three (2-3) min-
ute cool-down period at low idle
(600-800 RPM).
Step 2: Press the ENGINE START-STOP
button (all other models).
Step 3: If any problems were encoun-
tered during operation, have the
boat inspected by an authorized
MasterCraft dealer. Request any
necessary repairs before resuming
operation of the boat.
Step 4: At the conclusion of the out-
ing, turn the key off and remove
from the key slot. Doing so will
ensure that you have turned OFF
the electrical system, and prevent
others people from starting or run-
ning the boat.
Page 5-12 2014 MasterCraft Owners Manual • Preparation
P R E P A R A T I O N
To Next Page
Loading...
Need help?
General
