MasterCraft 2014 X10 User Manual

Page 7-36 2014 MasterCraft Owners Manual • MasterCraft Trailers
M A S T E R C R A F T T R A I L E R S
Possible cause: Foreign material in the
brakeunitassembly.
Remedy: Clean thoroughly. Replace the
shoes and linings if contaminated.
Possible cause: Insufcientamountofhy-
draulicuid.
Remedy: Fill the reservoir and bleed the
brakes. Check for leaks.
Possible cause: Brokelinesorpinchedline.
Remedy: Replace faulty lines and bleed the
brakes.
Possible cause: Seized actuator master
cylinder that prevents the piston from
stroking.
Remedy: Replace actuator master cylinder.
Possible cause: Corrosion/rust keeps
brakefromoperating.
Remedy: Replace damaged components or
entire brake assembly as required.
Problem:
One brake is overheating.
Possible cause: Disc brake caliper does
notpermitthebrakepadstorelease.
Remedy: Check the caliper. Sections must
be free to move apart. If frozen in place,
remove and free it up. Caliper piston may
freeze up and prevent pads from retracting.
Clean contaminants out of the piston cav-
ity. Replace the piston, seal and protective
dust cover boot. Bleed the brake system.
Possible cause: Leaky or seized brake
wheelcylinder.
Remedy: Replace/rebuild the wheel cylin-
der and replace the brake shoes if contami-
nated with brake uid. Clean the drums
and other hardware; readjust the brakes and
bleed the brake system.
Possible cause:Damagedorfrozenbrake
mechanism.
Remedy: Rebuild or replace the brake unit.
Problem:
More than one brake is overheating.
Isolate the problem to the actuator or the
brakes by:
1. Fully extend the actuator.
2. Remove the master cylinder reservoir
plug.
3. Check that the reservoir is properly
lled.
4. Manually push the actuator inner mem-
ber in or use a screwdriver to stroke the
push rod.
5. In the rst 1/8” of stroke, the reservoir
uid will either remain dead calm or
swirl around. If the uid swirls, uid is
allowed to return to the reservoir when
the actuator is extended. This means the
actuator is functioning properly and it is
necessary to troubleshoot the brakes.
Possible cause: Trailer has been stored
withtheactuatorcompressedandrusthas
causedthebrakestofreezeup.
Remedy: Remove the brakes. Clean, repair
or replace the components as necessary.
This is best done by an authorized Master-
Craft dealer.

MasterCraft 2014 X10 Specifications

General

Brand	MasterCraft
Model	2014 X10
Category	Boat
Language	English