47
9.8 DRIVE AXLE SET REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE
1) Turn off the power and disconnect the cord from the machine.
2) Remove the front disks from the machine as outlined in Section 9.1.
3) Remove both belts as outlined in Sections 9.5 & 9.6.
4) Release any bent tabs on the lock washer around the nut. Remove the 75mm nut from the assembly being serviced (Figure A). Shown with
special tool available from Matrix Fitness.
5) Remove the tapered split ring that is held in place by the nut (Figure B).
6) Remove the drive axle set and clean any debris from the frame (Figure C).
7) Reverse steps 1-6 to install a new drive axle set, making sure to tighten the 75mm nut to 100 N-m torque and rebend the lock washer tabs to
secure the nut. Reinstall the belts as outlined in Sections 9.5 and 9.6.
8) Test the Ascent Trainer for function as outlined in Section 9.19.
FIGURE A FIGURE B
FIGURE C
To Next Page
Loading...
Need help?
General
