48
9.9 CONSOLE REPLACEMENT
CHAPTER 9: PART REPLACEMENT GUIDE
1) Turn off the power and disconnect the cord from the machine.
2) Remove the 4 screws that hold the console to the top of the console mast (Figure A).
3) Disconnect the data cable, heart rate, and ground wires and remove the console (Figure B).
4) Reconnect the wire connections to the new console.
5) Carefully push the wires into the console and mast until they are clear of the console/mast connection and attach the console to the mast
using the 4 screws removed in Step 2.
6) Test the Ascent Trainer for function as outlined in Section 9.19.
FIGURE A
FIGURE B
To Next Page
Loading...
Need help?
General
