15
CHAPTER 7: SERVICE MODE / TEST MODE
7.1 SERVICE MODE OVERVIEW
1) To enter Service Mode, press number key "ENTER, 3, 0, 0, 1, ENTER" on the number keypad. Engineer Mode will appear on the display.
2) To scroll through the list of options in Service Mode, use the UP and DOWN LEVEL keys. Each of the custom settings will show on the
display.
3) To select a custom setting, press the ENTER key when the desired setting is shown.
4) To change the value of the setting, use the UP and DOWN LEVEL keys.
5) To confirm and save the value of the setting, press the ENTER key.
6) To exit the setting without saving, press the BACK key.
7) Press and hold the STOP key for 3-5 seconds to return to normal operation.
Group Item1 Item2 Default Value Values/Range Unit Notes
Accumulate Floors Current value 0~999999 Manually sets the Accumulated
Floors.
Time Current value 0~999999 Manually sets the Accumulated
Time
.
Log Error Display None Error0~Error10
/ None
Shows the last 10 errors.
Reset Reset error log..
Headphone Jack
Sensor
Insert Counts Current Value 0~999999 Insert headphone jack counts..
Reset NO NO-YES Reset headphone insert counts.
Configuration Export to USB Export engineer parameters to a
USB device.
Import from USB Import engineer parameters from a
USB device.
Factory Default Reset NO NO-YES Reset engineering default
to factory value.
Asset management Disable/Enable Disable Disable/Enable This option controls the AM
function is Disabled or Enabled.
Club ID This option records the club ID of
the fitness facility.
xID Login Enable/Disable Disable Disable/Enable This option controls the xID login
function is Disabled or Enabled.
To Next Page
Loading...
Need help?
General
