6
3.1 RECOMMENDED CLEANING TIPS
CHAPTER 3: PREVENTATIVE MAINTENANCE
In order to maximize life span, and minimize down time, all Matrix Fitness Equipment requires regularly
scheduled cleaning.
YOU WILL NEED:
- Mild dish soap and water mixture in a spray bottle (10:1 water to soap ratio).
- Lint free 100% cotton cleaning cloths or Micro fiber cleaning cloths.
- Vacuum / Shop Vac with extendable hose and soft brush attachment.
- Super Lube Multi Purpose Synthetic Lubricant with Syncolon® (PTFE) Aerosol - www.super-lube.com/sythetic-aerosol-spray-ezp-46.html.
- Corrosion Block (available from Matrix - part # ZMS4001374).
Gym wipes are okay for customers to use as they will not leave over spray on your product yet will clean & disinfect.
The soap / water and vinegar / water solutions recommended above are okay to leave on your floor for customers to use. NOTE: Vinegar is a
natural and safe disinfectant that will not cause corrosion.
We recommend that you do NOT allow customers to use spray bottles with chemical solutions to clean the equipment. If the cleaner is sprayed
directly on the equipment or overspray is present, it may cause your equipment to rust and / or cause damage to console overlays.
WEEKLY:
1. With a clean dry 100% lint free cloth and water / soap mixture, wipe down the entire frame including the stairs so it is free of dust, dirt, and
sweat.
2. With a clean dry 100% lint free cloth and water / soap mixture, wipe down the entire console area including the hand grips and hand rails.
MONTHLY:
1. Vacuum under and around the Climb Mill If you need to move the unit, unplug it first. Make sure to reset the casters after moving the unit
back into position to stabilize the unit.
QUARTERLY:
1. Remove the side access panels and vacuum out the inside of the unit (Figure B).
2. Unplug the Climbmill and clean the AUTO STOP SENSORS (located under the bottom step) sensor with a cotton swab and rubbing alcohol.
FIGURE B
MAINTENANCE SCHEDULE
ACTION FREQUENCY
Check step motion and stability to ensure the Climbmill does not rock or wobble. QUARTERLY
Check all connecting joint areas for tightness of bolt assemblies. QUARTERLY
Ensure that there is little, or no free play at all joint assemblies once bolts have been tightened. Installation of washer kits may
be required if free play does not come out from tightening bolts.
QUARTERLY
Unplug the Climbmill and remove the access panel. Clean sprockets of old grease and re-apply a lithium-based grease to
sprocket teeth.
QUARTERLY
Unplug the Climbmill and clean the AUTO STOP SENSORS (located under the bottom step) with a cotton swab and rubbing
alcohol.
QUARTERLY
To Next Page
Loading...
Need help?
General
