38
CHAPTER 7: PART REPLACEMENT GUIDE
7.12 DRIVE AXLE SET REPLACEMENT
1) Remove the front shrouds as outlined in Section 7.1.
2) Remove the drive belt as outlined in Section 7.8.
3) Pull the cap off of the crank / pedal arm connection (Figure A).
4) Remove the large nut holding the pedal arm to the crank (Figure B). NOTE: Be sure to notice the order of the washers as you remove
them for reinstallation (Figure C).
5) The front of the link arm can now be lifted away (Figure D).
FIGURE A FIGURE B
FIGURE C FIGURE D
To Next Page
Loading...
Need help?
General
