58
8.4 ASSEMBLY INSTRUCTIONS - CONTINUED
CHAPTER 8: ELLIPTICAL TRAINER SPECIFICATIONS AND ASSEMBLY GUIDE
CONSOLE MAST
1) Thread the Console Mast through the Console Mast Boot.
2) Feed the Console Cable through the Console Mast. Tape the Console Cable to the top of the Console Mast to secure it temporarily.
3) Attach the Console Mast to the Base Frame using two screws (Z03), four washers (Z04), and two nylon nuts (Z07).
4) Attach the Cup Holder Bracket to the Console Mast using the existing screws in the Console Mast.
CONSOLE
1) Connect the Console Cable inside the Console, and unscrew the four screws attached to the back of the Console.
2) Carefully push the wires into the Console and Console Mast until they are clear of the Console / Console Mast connection and attach the
Console to the Console Mast using the 4 screws taken from the back of the Console.
STEP 2
To Next Page
Loading...
Need help?
General
