3. When battery is fully charged, disconnect the
charger from the electrical socket, and then plug
the cable out of the phone.
When charging is completed, the display will show
"Charging completed" message for a moment, and, after
backlighting, the battery symbol will not pulsate.
2.2.1 Desktop charger (option)
When using a desktop charger, connect the small mains
charger plug to the socket of the desktop charger, and
then connect the power supply unit to the mains. Now, to
recharge the battery just put the phone into the desktop
charger with contacts facing down
Note:
o Prior to commencing charging, make sure the
battery is correctly installed
o When charging, do not remove the battery – you
can damage the phone
o If the battery voltage is too low for proper
operation of the phone, a message will be
displayed stating the phone will be automatically
switched off, and then the device will automatically
switch off.
o If the battery gets completely discharged (e.g.
because of leaving the flashlight on), after
connecting the charger, wait over ten minutes
before the charging symbol appears.
To Next Page
Loading...
Need help?
General
