English--- 12
115432326 Rev. 4 2/17/12
ASSEMBLY
Fitting a blade guard, g rass
blade and grass cutter
S Place the cupped washer (F) onto the
shaft with the cupped side of the washer
toward the blade.
S Install the blade retainer nut (G). Tighten
the nut using the wrench (provided).
Turn in the opposite direction to the di-
rection of rotation (CAUTION! left-hand
thread).
WARNING: Never use a cutting
attachment without an approved
guard. See the section on Techni-
cal data. If an incorrect or faulty
guard is fitted this can cause seri-
ous personal injury.
A
C
D
E
F
G
B
S Hook the blade guard/combination guard
(A) onto the fitting on the shaft and secure
with the bolt.
CAUTION! Use the recommended blade
guard. See the Technical data section.
S Turn the shaft until one of the holes in
the dust cup (B) aligns with the corre-
sponding hole in the gearbox.
S Insert a small screwdriver (C) in the hole
to lock the shaft.
S Place the blade (D) and retaining washer
(E) onto the shaft of the gearbox.
NOTE: Make sure the raised part of the
retaining washer is facing the gearbox
and the raised area fits into the hole in
the centre of the blade.
Fitting the trimmer guard and
trimmer head
S Hook the trimmer guard/combination
guard (A) onto the fitting on the shaft and
secure with the bolt (D ).
S Turn the shaft until one of the holes in the
dust cup (B) aligns with the correspond-
ing hole in the gearbox.
S Insert a small screwdriver (C) in the hole
to lock the shaft.
S Screw on the trimmer head (E) in the
opposite direction to the direction of
rotation.
S To dismantle, follow the instructions in
the reverse order.
D
A
A
B
E
C
Fitting blades
W ARNING:
When fitting blades,
it is extremel y important that the
raised section on the retaining wash-
er engages correctly in the centre
hole of the blade. If the blade is fitted
incorrectly , it can result in serious
and/or fatal personal injury.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
