10 IM710
Figure 4: Auxiliary Control Board (CCB1 Board Shown)
Analog Inputs Terminal Block (J8)
The auxiliary control board receives up to six analog input
signals via the AI (J8) terminal block on the right side of the
board.
Note: Only analog input AI5 is used with factory DX
cooling applications. The other five AI’s are not
used for self-contained, and are not supported in the
application software. Refer to “Analog Inputs-Aux-
iliary Control Boards (CCB1 and CCB2)” on
page 22 for details regarding analog inputs.
Binary Inputs Terminal Blocks (J9 and J10)
The auxiliary control board receives up to 12 binary input
signals via the BI terminal blocks (J9 and J10) on the right
side of the board. BI1 through BI6 are located on terminal
block J9 and BI7 through BI12 are located on terminal block
J10. Refer to “Binary Inputs-Auxiliary Control Boards
(CCB1 and CCB2)” on page 24 for details regarding binary
inputs.
To Next Page
Loading...
Need help?
General
