55
Getting started
Parking and locking
Switching off headlamps
왘 Turn the exterior lamp switch to M
(
컄 page 49).
For more information, see “Exterior lamp
switch” (
컄 page 119).
Turning off the engine
왘 Place the gear selector lever in
position P.
Turning off with the SmartKey
왘 Turn the SmartKey in the starter switch
(
컄 page 31) to position 0 and remove
it.
The immobilizer is activated.
왘 Press the seat belt release button
(
컄 page 44).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
왘 After exiting the vehicle press the lock
button ‹ on the SmartKey
(
컄 page 30).
All turn signal lamps flash three times.
The locking knobs on the doors move
down.
i
Always set the parking brake in addi-
tion to shifting to position P.
On steep slopes, turn the front wheels
towards the curb.
i
The SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
i
With the SmartKey removed and the
driver’s door open, a warning sounds if
the vehicle’s exterior lamps are not
switched off.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure there is no
possibility of someone getting caught in a
door during closing.
To Next Page
Loading...
Need help?
General
