114
Controls in detail
Memory function
ì™” Memory function
With the memory switch you can store up
to three different settings per SmartKey or
SmartKey with KEYLESS-GO*.
The following settings are saved for each
stored position:
앫 Driver’s seat and backrest position
ì•« Steering wheel position
ì•« Interior rear view mirror position
앫 Driver’s side exterior rear view mirror
position
ì•« Passenger side exterior rear view mir-
ror position
These key-dependent memory settings
can be deactivated if desired
(
컄 page 149).
The memory switch is located on the door.
M Memory button
1, 2, 3 Stored positions
왘 Switch on ignition.
or
왘 Open the respective door.
All the lamps in the instrument cluster
come on when the ignition is switched
on.
!
Prior to operating the vehicle, the driv-
er should check and adjust the seat
height, seat position fore and aft, and
seat backrest angle if necessary, to en-
sure adequate control, reach and com-
fort. The head restraint should also be
adjusted for proper height. See also the
section on airbags (
컄 page 59) for
proper seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, opera-
tion and comfort. Both the inside and
outside rear view mirrors should be ad-
justed for adequate rear vision.
Fasten seat belts. Infants and small
children should be seated in a properly
secured restraint system that complies
with U.S. Federal Motor Vehicle Safety
Standard 213 and Canadian Motor Ve-
hicle Safety Standard 213.
Warning! G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.
To Next Page
Loading...
Need help?
General
