333
Practical hints
Replacing bulbs
Notes on bulb replacement
ì•« Only use 12 volt bulbs of the same type
and with the specified watt rating.
ì•« Switch lights off before changing a bulb
to prevent short circuits.
ì•« Always use a clean lint-free cloth when
handling bulbs.
ì•« Your hands should be dry and free of oil
and grease.
ì•« If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Center.
Have the LEDs and bulbs for the following
lamps replaced by an authorized
Mercedes-Benz Center:
ì•« the additional turn signals in the exteri-
or rear view mirrors
ì•« the high mounted brake lamp
ì•« the brake lamps
ì•« the parking lamps and the side marker
lamps in the tail lamp assemblies
ì•« the rear fog lamps
ì•« the low beam (Xenon or Bi-Xenon*)
lamps
ì•« the front fog lamps
Warning! G
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing
a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas. A
bulb can explode if you:
ì•« touch or move it when hot,
ì•« drop the bulb,
ì•« scratch the bulb.
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
To Next Page
Loading...
Need help?
General
