Mercury Joystick Piloting for Outboards User Manual

Section 1 - Getting to Know the Joystick Piloting for Outboard
90-8M0093150 eng MAY 2014 Page 7
12. Install the washer and the M8 x 45 mm long screw. Tighten the screw to specification.
41350
Location of handle screw and washer
Description Nm lb‑in. lb‑ft
Handle screw 28.2 – 21
13. Install the emblem cover on the handle.
a - Side cover
b - Handle
c - Emblem cover
d - Slot
Dual Handle Yacht Console Control—Operation and Adjustment
Operation
Operation of shift and throttle is controlled by the movement of the control handle. Push the control handle forward from neutral
to the first detent for forward gear. Continue pushing the handle forward to increase speed. Pull the control handle back from
neutral to the first detent for reverse gear. Continue pulling the handle back to increase speed.
24559
F
N
R
78
O
78
O
Adjustment
1. Control handle tension adjustment screw ‑ This screw can be adjusted to increase or decrease the tension on the control
handle (cover must be removed). This will help prevent unwanted motion of the handle in rough water. Turn the screw
clockwise to increase tension and counterclockwise to decrease tension. Adjust to tension desired.
b
a
c
b
d
43425
b

Mercury Joystick Piloting for Outboards Specifications

General

Brand	Mercury
Model	Joystick Piloting for Outboards
Category	Marine Equipment
Language	English