Section 6 - Predelivery (PDI) and Customer Delivery (CDI) Checklists
90-8M0093150 eng MAY 2014 Page 49
N/A
Check/
Adjust
On‑the‑Water Test:
Neutral start safety switch operation
Lanyard stop switch operation (all helms)
Operation of instruments
Fuel, oil, and water leaks
Ignition timing
Forward, neutral, and reverse gear operation
Steering operation throughout range
Acceleration from idle RPM is normal
WOT________ RPM within specification (in forward gear)
Power trim operation
Confirm vessel personality list
Ensure that the steering wheel returns to center position when turning on the starboard engine key switch.
Perform IMU (compass) calibration and zero heading correction with CDS G3 Service Tool
Maneuver the boat to port by moving the joystick to full port. Ensure that undesirable movement can be corrected
by minimal operator joystick input.
Maneuver the boat to starboard by moving the joystick to full starboard. Ensure that undesirable movement can
be corrected by minimal operator joystick input.
Ensure that the vessel tracks a straight course at cruising speed. Perform drive alignment if required with CDS G3
Service Tool.
Enable the auto heading mode and drive for one minute at cruising speed ensuring that there is less than ± 5°
deviation to port or starboard.
Check the steering response by steering the boat from steering lock to lock at different speeds, starting at idle and
accelerating through cruising speed in 1000 RPM increments.
Perform a hard starboard turn at in‑gear idle while increasing to WOT while in turn. Ensure that boat steering
remains responsive.
Perform a hard starboard turn in gear at idle with all engines running. Turn the starboard engine off during the
turn. Ensure that the boat steering remains responsive.
N/A
Check/
Adjust
After the On‑the‑Water Test:
Propeller nut tightened to specification
Fuel, oil, water and fluid leaks
Oil and fluid levels
Apply Quicksilver Corrosion Guard to the engine package
Operation, Maintenance & Warranty manual is in the boat
Customer Delivery Inspection (CDI)
IMPORTANT: This inspection must take place in the presence of the customer.
This checklist is for packages equipped with outboard joystick. For engine packages not equipped with outboard joystick, use
the outboard PDI checklist located on the MercNet website. Perform these tasks after the Predelivery Inspection (PDI).
N/A
Completed Item
Operation and maintenance manual—provide to and review with the customer. Emphasize the importance of
safety warnings and Mercury engine testing procedures.
Approve the external appearance of the product (paint, cowl, decals, etc.)
Warranty—provide and explain the limited warranty to the customer. Explain your dealer services.
Explain the optional Mercury Product Protection Plan to the customer (North America only)
To Next Page
Loading...
Need help?
General
