DRIVE SHAFT / PROPELLER SHAFT MODELS
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 8F-13
2. Insert solid end of Quicksilver Alignment Tool through bearing in gimbal housing and into
input shaft splines of bearing support.
71401
a
b
Typical Stern Drive Unit Shown
a-Quicksilver Alignment Tool
b-Insert This End Of Alignment Tool Through Gimbal Housing Assembly
3. DO NOT remove alignment tool from gimbal housing.
CAUTION
Both attaching bolts MUST BE struck firmly in the following step to properly seat
spherical washers. If procedure is not followed, difficulty in the installation of the
sterndrive unit may be experienced and subsequent damage to the input bearing
may result.
4. Strike the head of BOTH bearing support attaching bolts firmly with a hammer.
71098
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General