PUMP SERVICE MANUAL NUMBER 23
Page 9A-14 90-861326--1 MARCH 1999
Low Pressure Hose (Control Valve-to-Cooler)
REMOVAL
NOTE: Catch fluid that drains from hose, cooler and pump in a suitable container.
1. Loosen hose clamp and remove hose from fluid cooler.
75595
a
a-Hose
2. Remove fitting from control valve at transom. Remove hose.
73860
a
a-Power Steering Hose Fitting
INSTALLATION
CAUTION
Route hoses exactly as shown below. This will help avoid stress on the hose fittings
and will help avoid kinks in the hoses.
IMPORTANT: Be careful to not cross-thread or over-tighten hose fittings.
1. Position hose properly (as prior to removal) Install fitting and torque to 23 ft. in. (31 N·m).
Do not cross-thread or overtighten.
73860
a
a-Power Steering Hose Fitting
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General