RISERS SERVICE MANUAL NUMBER 23
Page 7C-4 90-861326--1 MARCH 1999
IMPORTANT: On elbows with shift plate (MCM only) reinstall shift plate and tighten
fasteners securely, then readjust shift cables as outlined in appropriate Sterndrive
Service Manual.
7. Assemble harness bracket and plastic backup plate, if equipped, using four small
screws.
70244
a
b
c
d
e
f
Drop-Down Bracket For 6 Inch (152 mm) Riser
a-Riser Bracket
b-Harness Plate
c-Back-Up Plate (1)
d-Screws (6) 3/4 In. (19 mm)
e-Nuts (6)
f-Screws (4) 7/8 In. (22 mm)
8. Refill closed cooling system, if equipped. Refer to SECTION 6B - “Closed Cooled
Models.”
9. Upon first start-up of engine, check for leaks.
Exhaust Extension
1. Install appropriate exhaust extension for MCM Models with thru prop exhaust, using two
hose clamps at each end.
50930
a
b
Typical Exhaust Extension
a-Cut Along Bottom Edge Of Raised Bead For With 3 In. (76 mm) Riser
b-Leave Full Length For Use With 6 In. (152 mm) Riser
2. Tighten hose clamps securely.
3. Upon first start-up of engine, check for leaks.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General