454 CID (7.4L) / 502 CID (8.2L) SERVICE MANUAL NUMBER 23
Page 3A-38
90-861326--1 MARCH 1999
Valve Installation - Head Installed
7.4L
1. Place rotator or shim on valve spring seat.
2. Coat valve stem and new seal with engine oil. Install seal over valve stem.
3. If taken apart, reassemble damper and valve spring. Place on top of rotator or shim.
4. Set valve spring assembly and cap in position over valve stem.
5. Compress spring, using valve spring compressor, and install valve locks (grease may
be used to hold valve locks in place). Slowly release tool, making sure valve locks seat
properly in valve stem grooves.
72516
a
b
a-Valve Spring Compressor (J-5892)
b-Rocker Arm Nut
6. Install push rods and rocker arm assemblies. Torque to specifications.
7. Install rocker arm cover and torque to 71 lb-in. (8 Nm). Install spark plugs and torque
to 15 lb-ft (20 Nm).
454 MAG / 502 MAG / 8.2L
1. Place shim on valve spring seat.
2. If taken apart, reassemble damper and valve spring as shown. Make sure tighter wound
coils of spring and damper are on the same end.
72149
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General