VELVET DRIVE 5000V V-DRIVE TRANSMISSION
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 8C-11
Changing Transmission Fluid
Draining Transmission
1. Clean area around drain plug shown.
2. Remove dipstick and then remove drain plug. Drain oil from transmission into a suitable
container.
74604
a
Typical MIE Transmission
a-Drain Plug
3. Check oil for the following foreign matter:
• Metal Particles - A few small particles are normal. Larger metal chips are an early
sign of transmission failure which may mean transmission should be disassembled
and inspected for internal damage.
• Rubber Particles - Indication of cooler hose wear. Hoses should be inspected for
cracks or fraying. Replace damaged hoses.
NOTE: Coat threads of bushing with Quicksilver Perfect Seal and install in transmission
case if bushing came loose with elbow fitting. Torque bushing to 25 lb. ft. (34 N·m).
4. Coat elbow fitting threads with Quicksilver Perfect Seal and install in bushing. Tighten
securely.
5. Reconnect hose and tighten securely.
6. Refill transmission with specified fluid. Refer to “Filling Transmission”.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General