SEAWATER COOLED MODELS SERVICE MANUAL NUMBER 23
Page 6A-8 90-861326--1 MARCH 1999
Sea Strainer
NOTICE
Refer to manufacturer’s instructions for information on removal and installation of
other than Quicksilver Sea Strainer
Removal
CAUTION
If boat is in water while working on seawater strainer, close seacock, if so equipped.
If boat is not equipped with a seacock, remove and plug seawater inlet hose to pre-
vent a siphoning action that may occur, allowing seawater to flow from the drain
holes or removed hoses and enter boat.
IMPORTANT: Be certain engine is off and cooling system is cold.
1. Follow “a” or “b” instructions:
a. Models Equipped with Seacock:
(1.)Close seacock (seawater inlet valve).
(2.)Disconnect seawater inlet hose from seawater strainer.
72691
a
b
a-Seawater Inlet Hose
b-Seawater Strainer
b. Models without Seacock:
(1.)Disconnect seawater inlet hose from seawater strainer inlet and plug seawater
inlet hose.
70062
a
b
c
d
a-Seawater Inlet Hose
b-Seawater Strainer
c-Seawater Strainer Inlet
d-Plug
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General