SEAWATER COOLED MODELS
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 6A-9
2. Remove outlet hose. Drain into a suitable container.
72643
a
b
a-Seawater Inlet Hose
b-Seawater Strainer
3. Remove mounting bolts. Remove strainer.
Installation
IMPORTANT: Mount seawater strainer in a vibration-free location. Never mount it on
the engine or transmission. Hoses must not be kinked or allowed to come in contact
with hot or moving engine or transmission parts.
1. Mount seawater strainer. Arrow indicates required water flow direction and must point
toward seawater pump. Tighten mounting bolts securely.
72644
a
b
c
c
a-Seawater Strainer
b-Arrow
c-Mounting Bolt Hole Location (Bolts Not Shown)
2. Remove plug from seawater inlet hose (if installed previously) and install hose on
strainer. Install seawater outlet hose. Use two hose clamps on each hose connection.
Tighten clamps securely.
72645
a
b
cc
a-Seawater Inlet Hose
b-Seawater Outlet Hose
c-Double Hose Clamps
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General