SEAWATER COOLED MODELS
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 6A-23
Seawater Strainer
NOTICE
Refer to manufacturer’s instructions for information on checking and cleaning of
other than Quicksilver Seawater Strainer
WARNING
When cleaning seawater strainer, close seacock, if so equipped. If boat is not
equipped with a seacock, remove and plug seawater inlet hose to prevent a
siphoning action that may occur, allowing seawater to flow from the drain holes or
removed hoses.
CAUTION
Do not overtighten cover screws or cover will warp and leak.
Removal and Disassembly
1. Visually inspect seawater strainer through glass top.
2. With engine off, close seacock, if equipped. Remove and plug seawater inlet hose, if no
seacock exists.
3. Remove two screws and washers and cover.
4. Remove strainer, and drain plug and washer.
72673
a
b
c
d
e
f
g
h
Quicksilver Seawater Strainer Shown
a-Screws and Washers
b-Cover
c-Glass
d-O-Ring
e-Strainer
f-Housing
g-Drain Plug and Sealing Washer
h-Gasket
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General