6
MASTER RESET
You can return the gauge back to factory presets through the Master
Reset command.
IMPORTANT: Performing a master reset will reset the unit back
to all factory defaults, thus eliminating any installation
calibrations performed during set up of product.
1. Hold in
and for approximately 12 seconds. You will
see the word “dFLt”. Let go of the buttons.
2. Immediately press and hold in
and again until the
unit counts down to zero “0”.
3. The “SEt” message flashing on the screen indicates that the
unit has been reset to factory defaults.
To Next Page
Loading...
Need help?
General
