Emergency Stop Switch
An emergency stop (E‑stop) switch is used to turn off the engines in an emergency situation, such as a person overboard or a
tangled propeller. When activated, an E‑stop switch interrupts the power supply to the engine and transmission. If the boat is
equipped with an E‑stop switch, the E‑stop switch turns off all of the engines.
Typical E-stop switch
Activation of an E‑stop switch stops the engine, or engines, immediately, but the boat can continue to coast for some distance
depending upon the velocity and degree of any turn at shutdown. While the boat is coasting, it can cause injury to anyone in the
boat's path as seriously as the boat would when under power.
We recommend instructing other occupants on proper starting and operating procedures should they need to operate the
engine in an emergency.
Accidental or unintended activation of the switch during normal operation is also possible, which can cause any or all of the
following potentially hazardous situations:
• Occupants can be thrown forward due to unexpected loss of forward motion, and passengers in the front of the boat could
be ejected over the bow and possibly struck by the propulsion or steering components.
• The operator can lose power and directional control in heavy seas, strong current, or high winds.
• The operator can lose control of the vessel when docking.
Restarting an engine using the key switch or start button after an E‑stop shutdown without first turning the key switch to the off
position for at least 30 seconds will restart the engine but cause fault codes to be set. Unless you are in a potentially hazardous
situation, turn the key switch off and wait at least 30 seconds before restarting the engine or engines. If after restarting, some
fault codes are still being displayed, contact your authorized Mercury Diesel repair facility.
Remote Control
Remote Control Function
Operation of the throttle and shift are controlled by the movement of the control handle. Push the control handle forward from
neutral with a quick firm motion to the first detent for forward gear. Continue pushing forward to increase the engine RPM. Pull
the control handle back from neutral with a quick firm motion to the first detent for reverse gear and continue pulling back to
increase the engine RPM.
Section 1 - Getting to Know Your Power Package
Page 8 90-8M0133568 eng JUNE 2017
To Next Page
Loading...
Need help?
General