Mercury TDI 3.0L Operation And Maintenance Manual

2. Install the anode assembly with the washer into the intercooler end cover and tighten securely.
a - Anode
3. Unplug and connect the seawater inlet hose, or open the seacock if equipped.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
4. Ensure that the seawater pickup pump is supplied cooling water.
5. Start the engine and check for leaks.
Lubrication
Throttle Cable
Lubricate the pin and throttle cable surfaces with oil.
Throttle cable lubrication
a - Pin
b - Throttle cable
Tube Ref No. Description Where Used Part No.
80
SAE Engine Oil 30W Ball pin and throttle cable end contact surfaces Obtain Locally
Shift Cable
Lubricate the pivot points and guide contact surfaces.
Typical inboard model shift cable and transmission linkage
a - Pivot points
b - Guide contact surface
a
50781
a
b
52809
b
a
13347
Section 4 - Maintenance
Page 52 90-8M0133568 eng JUNE 2017

Mercury TDI 3.0L Specifications

General

Brand	Mercury
Model	TDI 3.0L
Category	Engine
Language	English