9. Using a 6 mm Allen wrench, turn the filter assembly nut clockwise to tighten. Tighten the nut to the specified torque.
a - Assembly nut
b - Fluid filter assembly
Description Nm lb‑in. lb‑ft
Filter assembly nut 7 62 –
10.
Fill the transmission to the proper level with the specified fluid. See Add Fluid.
Engine Coolant
!
CAUTION
A sudden loss of pressure can cause hot coolant to boil and discharge violently, resulting in serious injury from burns. Allow
the engine to cool down before removing the coolant pressure cap.
Checking
IMPORTANT: Check the engine coolant before starting the engine.
1. Stop the engine and allow the engine to cool.
2. Remove the pressure cap from the coolant expansion tank.
3. The coolant level must be above the minimum mark and below the maximum mark on the coolant expansion tank.
a - Pressure cap
b - Maximum mark
c - Minimum mark
IMPORTANT: The coolant level is monitored by a sensor. If the coolant level is low, a fault will be recorded, indicated on a
SmartCraft gauge, and a warning tone will be activated.
4. If the coolant level is low:
a. Inspect the coolant recovery system for leaks.
b
13173
a
Section 4 - Maintenance
Page 40 90-8M0133568 eng JUNE 2017
To Next Page
Loading...
Need help?
General