Adding Engine Oil
IMPORTANT: When filling or adding oil to the engine, always use the dipstick to determine how much oil is required. Do not
overfill the engine with oil.
1. Remove the oil fill cap.
a - Oil fill cap
2. Add the specified oil to bring the oil level up to, but not over, the maximum mark on the dipstick.
a - No oil required
b - Oil may be added but not to exceed range "a"
c - Oil must be added but not to exceed range "a"
NOTE: If the engine will be running for an extended period of time (10–12 hours), the oil level must be in the middle of the
MIN and MAX markings indicated on the dipstick.
3.0 L TDI
Fluid Type Capacity
Engine oil (with filter)
5W‑30 that meets VW 504
00/507 00 specifications
8.0 Liter (8.45 US qt)
Volume difference between the minimum and maximum markings on
the dipstick
1.3 Liter (1.4 US qt)
3. Install the oil fill cap.
Changing the Oil Filter
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil,
coolant, or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing
the disposal or recycling of waste, and contain and dispose of fluids as required.
Refer to the Maintenance Schedule for the change interval. You should change the engine oil before placing the boat in
storage.
IMPORTANT: Change the engine oil when the engine is warm from operation. Warm oil flows more freely, carrying away more
impurities. Use only recommended engine oil. Refer to Specifications.
1. Remove the top engine cover.
Section 4 - Maintenance
Page 36 90-8M0133568 eng JUNE 2017
To Next Page
Loading...
Need help?
General