37
• ON
This position is for power on of all electrical
accessories except HV electrical appliances.
Only the power switch is at the “ON”
position can the vehicle enter the READY
state.
Notes
If it is not necessary to start the vehicle,
please do not keep the key at “ON” for
a long time. Otherwise, the 12V battery
may be excessively consumed.
“READY” State (Start State)
When the vehicle enters the “READY” state,
all the HV working circuits will be turned
on, and the driving motor will be ready to
drive in gear. The “READY” state is similar to
the starting state of an internal combustion
engine vehicle.
Only when the vehicle enters the “READY”
state can you engage the gear and turn on the
A/C for cooling or heating.
How to Enter “READY” State:
1. Turn the power switch to “ON” first.
2. Then press the brake pedal until the
READY indicator on the instrument
panel illuminates.
After entering the READY state, the vehicle
will remain in this state until you turn off the
power switch to “ACC” or “LOCK”.
For keyless models, press the brake pedal
gently twice to enter the READY state.
How to Exit “READY” State:
Turn off the power switch to “ACC” or
“LOCK”. After the vehicle exits from the
“READY” state, the driving motor will exit
from the working state, and the vehicle
cannot be engaged in gear or run.
For keyless models, you can lock the vehicle
after getting off, and the whole system will be
turned off. Or you can press the OFF button
below the steering wheel to exit.
Notes
Do not use emergency button excessively.
Use only in case of emergency.
Driving and Controls
To Next Page
Loading...
Need help?
General
