MG ZS EV User Manual

137
Note: To avoid battery discharge, it is
recommendedtokeepthevehicleinPand
READYmode.
3 Switch on the power switch of the
electric compressor (i.e., press “-”), to
start pumping sealant into the tyre. The
tyre sealant bottle will become empty
after approximately 30 seconds. The
tyre should reach the specified pressure
within 5 or 10 minutes.
Note: The pressure gauge may briey
reach 600kPa (6 bar), then the pressure
beginstodroptonormal.
4 When the required pressure is reached,
switch off the power switch of the
electric compressor (i.e., press “O”).
Note: If the required pressure cannot
be reached within 10 minutes, please
disconnect the compressor, drive the
vehicle 10 metres approx forward or
backwardto allow the sealant to spread
within the tyre. If the required pressure
can still not be reached, the tyre is severely
damaged and you should seek assistance
fromtheRoadsideAssistancecompanyor
anMGAuthorisedRepairer.
Note:Continualoperationoftheelectric
aircompressorformorethan10minutes
mayresultindamagetothecompressor.
Note:Undernocircumstancesshouldyou
continue your journey with a deated
tyre.Drivingavehiclewithadeatedtyre
is extremely dangerous.
5 Remove the tyre sealant bottle from the
slot in the compressor, disconnect the
hose from the tyre valve, remove the
compressor plug from the centre console
power socket, return the tyre repair kit
to its stowage tray.
6 After successfully adding sealant to the
tyre, drive immediately for a short time
(around one minute). This will allow the
sealant to distribute evenly inside the
tyre. Continue driving and do not exceed
80 km/h. After a further 10 minutes, find
a safe place to stop and recheck the tyre
pressure.
Please follow different guidelines based
on the tyre pressure measured:
• If the tyre pressure has dropped to less
than 80 kPa (0.8 bar), do not continue
driving, seek assistance instead.
• If the tyre pressure is between 80 kPa
(0.8 bar) and specified pressure, use the
electric air pump to inflate the tyre until
it reaches the specified pressure. Repeat
the operations of step 6.
• If the tyre pressure has not dropped,
you may continue driving, but the vehicle
speed must not exceed 80 km/h, and the
driving mileage must not exceed 200km.
Note: Please regularly check the tyre
sealant ‘use by date’ and replace as
necessary.
Emergency Information
5

MG ZS EV Specifications

General

Brand	MG
Model	ZS EV
Category	Automobile
Language	English