24
Main Beam Switch
Take care not to dazzle oncoming
vehicles when driving using main
beamheadlamps.
Headlamp High/Low Beam
Switching
With the START/STOP Switch in the ON/
READY position and dipped headlamps are
switched on, push the lever (1) towards the
instrument panel to turn on headlamp high
beams. The high beam indicator lamp in
instrument pack illuminates, push the lever
(1) again or pull the lever (2) to switch to
headlamp low beams.
High Beam Flash
To briefly flash the high beam on and off, pull
the lever towards the steering wheel (2) and
then release.
Direction Indicator Switch
Move the lever down to indicate a LEFT turn
(1). Move the lever up to indicate a RIGHT
turn (2). The corresponding GREEN indicator
lamp in the instrument pack will flash when
the turning signal lamps are working.
Rotating the steering wheel will cancel the
indicator operation (small movements of
the steering wheel may not operate the self
cancelling). To indicate a lane change, move
the lever briefly and release, the indicators
will flash three times and then cancel.
Instruments and Controls
To Next Page
Loading...
Need help?
General
