MG ZS EV User Manual

148
Bulb Replacement
Before replacing any bulb, turn off the START/
STOP Switch and lighting switch to avoid any
possibility of a short circuit.
Note:MGonlyrecommendsreplacement
bulbs that completely meet the
manufacturersspecications.
Take care NOT to touch the glass with your
fingers; always use a cloth to handle the bulb.
If necessary, clean the glass with methylated
spirits to remove fingerprints.
If in doubt, when replacing bulbs, contact an
MG Authorised Repairer.
For replacement of other bulbs not listed
please consult an MG Authorised Repairer.
Interior Lamp Bulb Renewal (bulb
configuration)
1 Lightly prize up lampshade from the lamp
assembly with flat-blade screwdriver.
2 Pull the bulb out of the bulb holder.
The bulb refit procedure is in reverse order
with the bulb removal procedure. When
installing the lampshade, locate the two
prongs at the front of the lampshade and then
carefully flex the lampshade to locate the two
prongs at the rear of the lampshade into the
lamp assembly. Push the lampshade upwards
until it ‘clicks’ into position.
Load Space Lamp Bulb Renewal
1 Insert a suitable tool or small flat bladed
screwdriver into the indent on one of the
narrow sides (as arrowed in figure) of the
lens and carefully remove the unit from
its location.
2 Push while rotating the bulb to remove it.
The bulb refit procedure is in reverse order
with the bulb removal procedure.
Emergency Information

MG ZS EV Specifications

General

Brand	MG
Model	ZS EV
Category	Automobile
Language	English