35
“One-Touch” Up with “Anti-Trap”
The driver’s window control switch (1) has
the “one-touch” up function. Lifting the
switch to the “2” position for a short time
and releasing will automatically close the
window completely. Window movement can
be stopped at a desired position at any time
by briefly operating the switch again.
The “Anti-Trap” function is a safety feature
which prevents the window from fully closing
if an obstruction is sensed - if this happens
the window will open slightly to allow the
obstruction to be removed.
Note: DO NOT operate the power
window controls continuously several
times in a short time frame, otherwise the
power window controls may be disabled
toprotectthemotor.Ifthisoccurs,please
wait a few seconds until the motor cools
down. In the case of the driver’s window
with “One Touch and Anti-Trap” please
wait 30 seconds prior to operation. In
some cases it may take 30 minutes to
completelycooldown,duringwhichtime
the negative battery lead should not be
disconnected.
Note: If the battery is disconnected, the
“One-Touch” and “Anti-Trap” features
will be lost. To restore this feature, fully
close the window and hold the switch for
5seconds,andthenfullyopenthewindow
andpresstheswitchfor5seconds.
Instruments and Controls
1