MG ZS EV User Manual

39
Linkage between Sunshade and Sunroof
Glass
To prevent the sunshade from being exposed,
the sunshade will move together with the
sunroof glass as one unit when the sunroof is
opened. To close the sunshade, please close
the sunroof glass first.
Sunroof Initialisation
In the event of a power failure or battery
disconnection when the sunroof glass or
sunshade is in motion, the sunroof/sunshade
will require initialisation when the power is
restored.
To carry out the sunroof glass initialisation
operation:
Fully close the glass - gently slide the switch
forward to the 2nd position and hold in
position for 10 seconds. The sunroof will
open a preset amount and stop, it will then
close automatically - the sunroof glass is then
initiailised. During the whole process, the
switch must remain in the 2nd position.
To carry out the sunshade initialisation
operation:
Fully close the sunshade - slide the close
switch forward to the 2nd position and hold
in position for 10 seconds. The sunshade will
open a preset amount and stop, it will then
close automatically - the sunshade is then
initiailised. During the whole process, the
switch must remain in the 2nd position.
Thermal Protection
To prevent the sunroof glass motor and the
sunshade motor from being overheated and
damaged, the motors are designed with a
thermal protection function.
After the thermal protection function is
activated, the sunroof/sunshade does not
respond to other operations except the
closing operation. After the motor has cooled
down and exits the thermal protection state,
the sunroof can be operated normally until
the next thermal protection event.
Instruments and Controls
1

MG ZS EV Specifications

General

Brand	MG
Model	ZS EV
Category	Automobile
Language	English