CCM-270A/WS
38 201807
CCM-270A/WS Service Manual
1.12 Install the IDUs
For Touch Screen: This step is same for both touch screen as well as computer website.
For Computer website: This step is same for both touch screen as well as computer website.
After successful login, we need to install the IDUs. We will reach the homepage of CCM-270A/WS. Click on the Install Tab
to enter the Installation page
On the installation page, select the required installation mode that is Auto Topology or Manual Topology (written as Auto
topo and Manual topo) respectively.
Auto Topology: When V6/VX ODU is connected with 2
nd
Generation DC IDUs.
Manual topology: When non-V6/VX ODU is connected with 2
nd
Generation DC IDUs or V6/VX ODU is connected with 1
st
Generation AC/DC IDUs.
How to use Auto Topology:
1. Click Auto topo.
2. Wait for 7 minutes and then check the results.
Important Points:
1. Ensure that ODU has started and completed auto addressing before using this topo setting.
2. Do not operate the centralized controller during this time to prevent topo failure.
3. It takes about 7 minutes to complete the installation process. The user needs to wait patiently.
How to use Manual topology:
1. Write the Manual Topology document.
2. Store the Manual Topology document in the USB disk and connect the USB disk with the USB port of centralized
controller.
3. Click Manual topo on the “Install” page.
4. Select the completed Manual Topology document in the pop-up dialog box and start topology.
5. After topology is completed, check the results.
To Next Page
Loading...
Need help?
General
