WARNING
After finishing the electrical work, confirm that each electrical component and terminal inside the
electrical cabinet is securely connected.
Make sure all covers are closed before starting up the units.
WARNING
Do not install the CCM-270A/WS near areas of electromagnetic interference or next to base station.
Locate the CCM-270A/WS away from sources of steams, possible flammable gas leaks, heat or sulfurous
gases.
Reserve sufficient space for the installation, and leave adequate spacing between the device and
surrounding community service network devices for heat dissipation.
Make sure that the installation site is indoors and the CCM-270A/WS is installed at a height that is 50 cm
above the ground.
Make sure that the installation site is not exposed to sun and heating devices.
Make sure that the device is not installed in humid places or where it is easy for device to come in
contact with water.
Make sure that the device is not installed in locations where it can be easily corroded or where there are
flammable gases.
Please install the gateway device in strict accordance with the above instructions and do check the
installation site carefully before installation.
To Next Page
Loading...
Need help?
General
