CCM-270A/WS
96 201807
CCM-270A/WS Service Manual
8.2.1 Create, Edit and Delete Group
Tap at the bottom left corner to go to the pages to create, edit and delete group. The CCM-270A/WS
supports three group levels. The three levels of the groups have been created with the notion that suppose there is a
building, it will be a Level 1 group, each floor of building then becomes the Level 2 group and each room on the floor then
would be the Level 3 group. The user can also set the groups according to his understanding and convenience.
Tap the back key at the lower-left corner to return to the group page.
Create Group
Tap , and you will get a textbox for you to edit the group at the corresponding level and the mouse is
active.
Enter the name. Tap the CR ("Go") key on the keyboard, or tap in the blank space to exit the editor. Groups at the same
level cannot have the same names. Maximum group name can be of 12 characters. You will receive a prompt during "Save"
if the name exceeds 12 characters.
To Next Page
Loading...
Need help?
General
