Midea 50Hz AC Fan Coil Unit Two-pipe Wall-mounted Series MCAC-UTSM-201606
- 43 -
indoor unit lights. The operating mode of AUTO FAN SPEED is automatically set and there are no indicators
shown on the display panel of the remote controller.
4. Push the ON/OFF button again to stop the unit.
Notes:
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN, HEAT and DRY by
sensing the difference between the actual ambient room temperature and the set temperature on the remote
controller..
2. If the AUTO mode is not comfortable for you , the desired mode can be selected manually.
COOL, HEAT, and FAN ONLY Operation
• If the AUTO mode is not comfortable, you may manually override the settings by using COOL, DRY,
HEAT(HEAT PUMP units only), or FAN ONLY modes.
• Push the TEMP button to set the desired room temperature. When in COOLING mode, the most comfortable
settings are 21℃ or above. When in HEATING mode, the most comfortable settings are 28℃ or below.
• Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
• Push the ON/OFF button. The operation lamp lights and the air conditioner starts to run according to your
settings.
• Push the ON/OFF button again to stop.
Note:
The FAN ONLY mode cannot be used to control the temperature. While in this mode, only steps 1, 3 and 4 may
be performed.
Dry Operation
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from 21℃ to 28℃.
3. Push the ON/OFF button. The operation lamp lights and the air conditioner starts to run in the DRY mode. 4.
Push the ON/OFF button again to stop the unit.
Note:
Due to the difference of the set temperature of the unit and the actual indoor temperature, the Air Conditioner
when in DRY mode will automatically operate many times without running the COOL and FAN mode.
Time Operation
PUSH TIMER button to set the on and off times of the unit.
1. To set the STARTING time.
1) Please push the CANCEL button to cancel any former settings.
2) Push the TIMER button. The remote controller will show the TIMER and the signal "h" is shown on the display
panel. The control is now ready to reset the TIMER ON to start the operation.
3) Push the TEMP button ( or ) to set desired unit START time .
4) After setting the TIMER there will be a one-half second delay before the remote controller transmits the signal
to the Air Conditioner. Then, after approximately another 2 seconds, the set temperature will re-appear on the
digital display.
2. To set the STOPPING time.
1) Please press the CANCEL button to cancel any former settings.
2) Push the TIMER button and the remote controller will show the last set time for the START operation and the
signal "h" will be shown on the display panel. You are now ready to re-adjust the TIMER OFF to stop the
operation.
3) Push the TEMP button to cancel the TIMER ON setting. The digital area will show "00".
4) Push the TIMER button and the remote controller will show the last set time for the STOP operation and the
signal "h" will be shown on the display panel. You are now ready to reset the time of the STOP operation.
5) Push the TEMP button ( or ) to set the time you want to stop the operation.
6) After setting the TIMER there will be a one-half second delay before the remote controller transmits the signals
To Next Page
Loading...
Need help?
General
