All electrical work should be carried out only by a suitably
competent person, in strict accordance with national and
local safety regulations.
The machine is supplied with a mains cable with moulded
plug for connection to a 220 - 240 V mains supply. The
voltage, rated load and plug rating are given on the data
plate. Please ensure these match the household mains
supply.
Connection should be made via a switched socket which is
easily accessible after installation. For extra safety it is
advisable to install a residual current device (RCD), with a trip
current of 30 mA. Do not connect via an extension lead.
Test marks Electrical safety, C-Tick Mark
Electrically suppressed according to AS/NZS 1044
Important
The wires in the mains lead are coloured in accordance with
the following code:
Green/yellow = earth
Blue = neutral
Brown = live
Where it is necessary to change plugs, if the colours of the
wires in the mains lead of this machine do not correspond with
the coloured markings identifying the terminals of your plug,
proceed as follows:
The wire which is coloured green and yellow must be
connected to the terminal in the plug which is marked with
the letter E or by the earth symbol z or coloured green, or
green and yellow.
The wire which is coloured blue must be connected to the
terminal in the plug which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to the
terminal in the plug which is marked with the letter A or
coloured red.
WARNING: THIS MACHINE MUST BE EARTHED
Electrical connection
79
To Next Page
Loading...
Need help?
General
