Operation (Automatic and Manual modes)
25
Activating and altering the charcoal
filter operating hours counter
Charcoal filters are needed for recircu‐
lation mode.
The charcoal filter operating hours
counter needs to be activated once and
the operating time needs to be set to
suit the kind of cooking you do:
Use the On/Off control to switch
the fan off.
Press the "" symbol and the oper‐
ating hours control at the same
time.
The Charcoal filter symbol and one
of the fan power levels will flash.
Fan power level indicators 1 to IS show
the time set:
1............................................. 120 hours
2............................................. 180 hours
3............................................. 240 hours
IS ........................................ Deactivated
Press the "" symbol for a shorter
operating time, or the "" symbol to
select a longer operating time.
Confirm your choice by pressing the
operating hours control .
All the indicator lamps will go out.
If you do not confirm within 4 minutes,
the cooker hood will revert to the old
setting.
Reading the filter operating hours
counter
To check the percentage of time set al‐
ready used
Use the On/Off control to switch
the fan on.
Press and hold the operating hours
control
– Once, to read the Grease filter oper‐
ating hours. The grease filter symbol
lights up.
– Twice, to read the Charcoal filter op‐
erating hours. The Charcoal filter
symbol lights up.
One or more of the power level indica‐
tors will flash.
The number of fan power level indica‐
tors flashing shows the percentage of
the operating time which has already
been used up.
1 ................................................... 25 %
1 and 2 ......................................... 50 %
1 to 3 ............................................ 75 %
1 to IS ......................................... 100 %
The number of operating hours used
remains in the memory, even when
the appliance is switched off or there
is a power cut.
To Next Page
Loading...
Need help?
General
