Activating Con@ctivity 2.0
53
Activating the hob
While the cooker hood is searching
for a signal, start activating the hob.
More information about this can be
found in the Operating instructions
for the hob.
When the hob registers that connec‐
tion has been established, confirm
activation on the cooker hood with
the run-on option control 515. All
indicators will go out.
Confirm activation on the hob.
Con@ctivity 2.0 is now ready to use.
If you do not confirm within 4 minutes,
activation will not take place.
You only need to carry out the activa‐
tion procedure once. If the appliances
are disconnected from the electricity
supply, during a power cut for exam‐
ple, they will still remain activated.
Activation failed
If connection cannot be established
despite activating the Con@ctivity
function on the cooker hood and
hob, the function must be deactiva‐
ted on both appliances and then the
procedure repeated.
Deactivating Con@ctivity 2.0
Deactivation on the cooker hood is
carried out in the same way as acti‐
vation, by selecting "" instead of
"".
To deactivate the hob, please refer to
the Operating instructions supplied
with it.
Please bear in mind that disabling the
signal will also disable any remote
control function and this will have to
be activated again.
To Next Page
Loading...
Need help?
General
