Activating Con@ctivity 2.0
52
Installing the Con@ctivity 2.0
Stick
In order to use the Con@ctivity 2.0
function, the hob must first be fitted
with the Con@ctivity 2.0 Stick.
Please read the separate installation
instructions supplied with the
Con@ctivity 2.0 Stick.
Activating Con@ctivity 2.0
Wireless connection must be activated
between the hob and the cooker hood
before the Con@ctivity 2.0 function can
be used.
Both appliances must be installed and
operational.
Wireless connection must be activated
on the cooker hood and the hob at the
same time. Activation on the cooker
hood is described below.
Activation on the hob is described in
the relevant Operating and installation
instructions. Please refer to the Operat‐
ing instructions before starting.
Activate the cooker hood first, then the
hob.
Activating the cooker hood
The hob and cooker hood must be
switched off.
Press the run-on option button 515
for approx. 10 seconds until the indi‐
cator for power level 1 lights up.
Then press in turn,
– the "" button,
– then the "" button,
– then the lighting button .
The cooker hood is now in signing
on/off mode.
If a wireless connection has not yet
been established 2 and 3 will flash at
the same time.
If a wireless connection has already
been established, 2 and 3 will light up
constantly (Con@ctivity 2.0 is already
activated or a remote control is signed
on).
To activate Con@ctivity 2.0, press the
"" button.
The search for a signal will start.
Meanwhile, start activating the hob.
To Next Page
Loading...
Need help?
General
