Attach the exhaust ducting, e.g. flexi‐
ble hose, to the exhaust socket using
a hose clip (available as an optional
accessory). When using 125 mm
ducting, fit the reducing collar sup‐
plied into the exhaust socket (see
"Connection for air extraction").
Attach the exhaust ducting to the ex‐
haust socket on the cooker hood.
See "Connection for air extraction"
for further instructions on fitting the
ducting.
Setting up for recirculation
mode
If site conditions are not suitable for the
cooker hood to be used with air extrac‐
tion, the appliance must be set up for
recirculation. A conversion kit, available
through your dealer of from Miele is re‐
quired for operating the cooker hood in
recirculation mode. You will also need
two charcoal filters (see "Technical da‐
ta").
Conversion kit DUU 150 with a plastic
grille is suitable for fitting in a non-visi‐
ble area at the top of the wall unit.
Conversion kit DUU 151 with a stain‐
less steel grille is recommended if the
grille is to be fitted in an area which is
visible.
Fit the conversion kit as described in
the installation instructions supplied
with the kit. Make sure that the slats
in the exhaust grille point towards the
centre of the room and not towards a
To Next Page
Loading...
Need help?
General
