Signing on/off the remote control
56
If the connection has been lost between
the r
emote control and the rangehood,
the remote control and the remote
control function on the rangehood must
be signed on again. To do this, the
remote control function on the
rangehood and the remote control must
first be signed off.
Signing on/off is carried out with the
deflect
or plate retracted.
Remove the grease filters.
The controls are accessible via the slots
for the gr
ease filters.
Signing on and off must be done at the
same time on
the rangehood and the
remote control. Signing on/off mode
has to be accessed on the rangehood
first, then on the remote control.
Accessing signing on/off mode on
th
e rangehood
P
ress the run-on option control
515 for approx. 10 seconds until
the indicator for the power setting 1
lights up.
The
n press in turn,
– the "" contr
ol,
– then the "" control,
– then the lighting control .
Then access the signing on/off mode
on the
remote control immediately.
Accessing signing on/off mode on
the remote control
P
ress both arrow controls at the
same time and hold for about 5
seconds until the remote control LED
flashes.
P
ress the lighting control .
Signing off
In s
igning on/off mode press the ""
control on the rangehood and then
on the remote control.
The remote control LED will flash
st
eadily.
After approx. 10 seconds the remote
contr
ol LED will flash on and off twice
with a longer interval between the
flashes. The remote control has now
been signed off. The LED will go out
after a short while.
To Next Page
Loading...
Need help?
General
