Coupling seal
If the water container becomes difficult to remove and
replace or the fault message F20 appears, rub a small
amount of the silicone grease supplied (see "Description of
the appliance > Accessories supplied") into the inside of the
coupling seal. Do not take the seal out to lubricate it.
When handling silicone grease, please observe the following
safety measures:
–
Remove silicone grease from skin by rinsing off with water.
–
If the grease gets into the eyes, it must be rinsed out with
plenty of clean water.
–
If it is swallowed, seek medical advice.
The coupling seal should be replaced with a new one if it
becomes brittle or porous or if an unusually large amount of
water collects on the floor of the water container
compartment.
Coupling seals can be ordered from Miele.
Only use the silicone grease supplied. On no account
should margarine, oil or any other domestic grease or fat
be used, as these can cause the seal to swell.
Cleaning and care
78