Before using for the first time
29
Activating AutoDos
The display changes to the settings
screen for AutoDos (see the “Detergent”
chapter, “Automatic dispensing/Auto-
Dos” section).
Even if you do not wish to use Auto-
Dos, you must remove the transport
locking device from the PowerDisk
compartment before running the first
programme (see the “Detergent”
chapter, “Activating AutoDos” sec-
tion).
You can activate AutoDos.
If you do not wish to use AutoDos
(automatic dispensing), you can manu-
ally dispense the detergent via the de-
tergent compartment (see the “Deter-
gent” chapter, “Manual detergent dis-
pensing” section).
Select the setting you want and con-
firm with OK.
This setting applies to all programmes
and you can change it in a pro-
gramme's Extras menu.
Finally, prompts will appear in the dis-
play.
After confirming these prompts with
OK, the messages Add salt and run the
“QuickPowerWash” programme with the
“Express” option without a load and Re-
fill rinse aid may appear.
Add salt and rinse aid if necessary
(see “Before using for the first time –
Dishwasher salt” and “Rinse aid”).
Select OK to confirm the messages.
The selected programme will be shown
briefly in the display.
Next, the estimated energy and water
consumption may be shown for the
chosen programme for several
seconds.
Then the display will show the estim-
ated running time for the programme
selected.
To Next Page
Loading...
Need help?
General
